![]() ![]() Rebooting obscures what is happening and doesn't make your system work. I recommend you not boot up again until you observe the specific symptoms. ![]() Since they were probably all powered up at different times, not many will check in at the same moment. At the check-in, it sends its Normal/Open status. Once it's sent an Open/Fault signal, unless it closes it won't send another signal until Check-in time, which is every hour or so (a little less). Each sensor sends a signal when it Opens (Faults) and when it Closes (Normal). When you panel boots up, it assumes any wireless zones are Normal (Ready to Arm) until it receives transmissions from them. Then they will all fault during the next hour as they send "Check-in" signals and report they are Open. You can have all doors and windows open, and reboot, and all doors and window zones will show Ready to Arm. It clears the symptom.ĮDIT: Duh! I'm not going to delete all this, but skip down to where I say, EDIT: Duh! again.Īssume you have a perfectly working system with wireless sensors. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |